![]() ![]() ![]() Don't use it, don't let your friends use it, send a bottle to your enemies, etc. I hope it didn't do something to the finish.Īnyway, my blunt verdict is that this stuff is junk. I really don't understand why the waxed areas are beading less than the unwaxed now. So definitely the streaks and the wax are related. The streaks petered out as they went down it, then picked back up on the lower section that had been waxed. So I took a closer look, and sure enough, there were no black streaks on that patch. More interesting is that here was one patch that was still beading, and I'd remembered that I didn't wax that part because I wanted to reapply the graphic there since it had a small crease in it. After it sat for a while it would, but not like it was before. I used Rejex on the new corvette and Finish First on the Rav 4.Buy Rejex on Amazo. What surprised me was that the water wasn't beading anymore, which is weird because it beaded with just the bare fiberglass. Comparing two popular auto polishes to see if one is better than the other. I think what's left is faint enough though that only I'd notice. I'll have to find some sort of solvent to try to get it off there. I just washed both the truck and trailer for the first time since waxing - the black streaks came off without too much effort, except for on the window trim. It is very satisfying compared to the old routine of multiple hard scrubbings, which is hard on you and also hard on the gelcoat. ![]() I only need half a bottle of Rejex to do "Mouse".ĭried three week old bug carcasses on the front wall do not "rinse off" but they do come off completely with absolutely minimal pressure. That gives you eight clean sides to work with. I use square cotton rags folded twice to apply, flipping when they start to turn black. It smells a little but it does not knock your head off like MEK or acetone. use with gloves and adequate ventilation. The product dries water clear, and unlike wax-based products. I suggest that you buy two quarts to be safe, and for future use. RejeX has a higher refractive index than any wax, so it produces richer, deeper looking colors. You need about half a quart to do an Elite II, including the roof, if it isn't too dirty/ spotty. You can get it locally from an auto paint supply store for as little as $15 per quart (and no shipping). Dawn dish detergent will strip off wax, and a followup with a paint prep solvent like this. You must remove all existing wax from the surfaces before applying. (Great for dark colored cars with paint in good condition.) It is amazing stuff, and a single coating will make your Ollie glow. You cannot find a more satisfying product than Rejex. ![]()
0 Comments
Leave a Reply. |